Lights, Signals, Switches and Handlebars
• Check all lights, meters, indicator lights and electrical connections to make sure
they are all in proper working condition.
• Check the handlebars make sure they turn both ways smoothly.
Tires
• Always check the tires before riding, be sure they are in good condition, check
for nails, glass or any other items that may puncture your tire. Check for cracks
in the side wall. If there are any problems with the tires please
replace immediately.
Tire Pressure
• To ensure maximum performance and safe operation please check the tire
pressure before riding. Do not over inflate your scooters tires because the
handling characteristics are different when the maximum air pressure
has been exceeded.
• Front Tire Pressure: 28 psi (cold)
• Rear Tire Pressure: 34 psi (cold)
Brakes
• Check the brakes before you ride each time if they are soft and spongy or are not
working right, please replace immediately.
• Check your brake fluid level, add if necessary.
• Apply the brakes and make sure that the fluid is not leaking out of the brake
lines or the master cylinder.
NOTE:
Brake fluid may destroy painted surfaces or plastic parts, be sure to
clean up all spills.
Brake Fluid Level
1. When checking the fluid level make sure the top of the brake master cylinder
is level by centering the handlebars.
2. Refill with DOT 3 brake fluid. Mixing fluid may result in a harmful chemical reaction
and lead to poor brake performance.
3. Be careful that water does not enter the master cylinder when refilling.
8
Please have the last 7 digits of your VIN# ready when you call for parts.
Have a problem - Need parts - Please call Toll Free (866) 658-7300 • Email: parts@wildfiremotors.com
7
Starting Off, Riding, Stopping and Parking Before starting,
put the side stand up.
(1).Turn the key to the on position.
(2).Apply the rear brake.
(3).With the throttle at idle position push the electric start button or use the kick
start: if the engine fails to start turn and release the throttle then push the electric
start button or kick start again. Be sure and replace the kick starter to its original
position before riding.
(4).If the bike is on the center stand hold the handle bars with both hands and push
forward, if the bike is on the kick stand hold the bike up and push the kick stand
with your foot.
(5).For a cold engine, let the engine idle for 1-3 minutes before riding.
(6).Sit on the bike keeping one foot on the ground for stability, release the brake and
twist the throttle to accelerate, after you start to accelerate put both feet on the
foot rest only putting them on the ground when coming to a stop.
(7).When coming to a stop decrease your speed by releasing the throttle and
apply both of the brakes, if the front tire begins to skid release and reapply.
(8).Parking: Turn the handlebars to the left as far as they will turn, then turn the
key to the lock position (this will lock the steering, remove the key, to avoid
theft.) Put your kick stand down or use the center stand.
NOTE:
The muffler
and exhaust pipe are hot. Park away from pedestrians.
(9). Practice in an empty parking lot or driveway until you feel confident enough
to ride on the street.
(10). When preparing to ride on a street make sure the headlights are on, check
for traffic and use your turn signals at all times remember to turn the signals
off after use.
(11). Always remember to obey your local and state laws and regulations.
