16
Timer
Select “On” if the camera should only be active during a certain time period. In the sub- menu, you can set the start and
end time for PIR mode and timelapse mode
Press the up/down buttons to set the hour for the start of the active phase. Then switch to the next field using the right
button. Press the up /down buttons to set the minutes for the start of the active phase.
The settings made here apply every day. The camera will not record any images outside of the active phase.
Confirm your selection with the OK button. Afterwards, press the MENU button to close this sub-menu.
Password Setting
Select “On” if you want to use a password to protect the camera from unwanted access. In the following screen menu, you
can set a 4-digit combination:
Press the up /down buttons to select the first digit between 0–9.
Then switch to the next field using the right button. Press the up /down buttons to select the second digit between 0–9.
Confirm your selection with the OK button. Afterwards, press the MENU button to close this sub-menu.The set number
combination must now be entered each time the camera is switched to test mode.
If you forget the number combination, please ask the supplier for firmware to reset it to its factory default settings.
Summary of Contents for GUARD1 Series
Page 9: ...9...
