29
■
Clean the surfaces of the device with a soft, dry cloth. Use a normal commercial detergent and water to remove
stubborn residue. Ensure that no water gets into the device.
■
Always keep the seal clean so that no moisture gets into the device and damages it. Contamination of the seal can impair
the dust and water spray protection .
Handling and operation
In this chapter you will receive important information for the handling and operation of the device.
5
. Trouble Shooting
5.1 Photos Do Not Capture Subject of Interest
1. Check the “Sensor Level” (PIR sensitivity) parameter setting. For warm environmental conditions, set the
Sensor Level to “High” and for cold weather use, set the sensor for “Low”.
2. Try to set your camera up in an area where no heat resources are in the camera’s field of view.
3. In some cases, set the camera near water will make the camera take images with no subject in them. Try
to aim the camera over ground.
Summary of Contents for GUARD1 Series
Page 9: ...9...