W01/02PRI Pre 2017 - Quick Installation Guide - English
W01/02PRI Pre 2017 - Quick Installation Guide - English
Page 2 of 5
On the rear panel of the gateway there are five network ports:
ETH5 port: used as WAN port
ETH1 – ETH4: used as LAN port
Access via WAN port:
Connect WAN port (ETH5) to the same network as the PBX or an external DHCP server (for instance, its
Router)
As soon as the DHCP server assigns an IP address to the gateway, you can pass to the next step of the
gateway configuration
In case the PBX is used as a DHCP server, the gateway is detected on the network automatically
In case an external DHCP server is used, check the list of the active leases to detect the IP address
assigned to the gateway
Connecting W01/02PRI using DHCP server
Before you start:
Make sure that your network connection is working
You must use an IPv4 Network
The IPv4 Network must have a DHCP server
If you do not have access to the DHCP server's logs, then follow instructions described in Connecting W01
/02PRI using a static IP address
Steps
Connect a 10/100/1000 BaseT Ethernet RJ-45 cable into the ETH1 connector of the device
Connect the other end of the cable to a router/switch connected to your Network
Validate the installation
Turn on the power sources that are used to power the gateway at the circuit breaker
Turn on the power switch of the PRI gateway
Consult the DHCP server's logs to find out your IP address
Result
