W01/02PRI Pre 2017 - Quick Installation Guide - English
W01/02PRI Pre 2017 - Quick Installation Guide - English
Page 4 of 5
Reset of the gateway
In case you need to reconfigure the gateway, you should perform a reset procedure, as shown on the picture.
The switch marked as “
” is situated on the rear panel of the gateway.
Reset/Default
Use the paper clip or the object of the similar shape to press the button
Hold the button until all the LEDs of the gateway stop blinking and remain turned on (circa 10 seconds)
Release the button and wait for the reboot of the gateway
In case the LEDs remain turned on for more than one minute after the reset procedure, disconnect the power
supply and repeat the reset procedure when the device starts.
Mounting racks
Attach two racks provided with the gateway to the device, as shown on the picture:
