OPERATION
1.
Turning the unit on:
When the unit is plugged in, a buzzer will beep and the unit will start to
run at low fan speed.
Press
to start.
2.
Turning the unit off
Press the POWER button
to stop dehumidification.
Never stop the unit by unplugging the power cable.
DRAINING THE COLLECTED WATER
When the drainage tank is full, the tank full indicator light will turn on, the
operation will stop automatically and the buzzer will beep 15 times to alert the
user that the water needs to be emptied from the drainage tank.
Emptying the Drainage Tank
1.
Hold the top and bottom of the water tank in the middle with both hands
and pull it out gently.
2.
Discard the collected water
NOTE
1.
Do not remove the float from the water tank. The water full sensor will no
longer be able to detect the water level correctly without the float and water
may leak from the water tank.
2.
If the drainage tank is dirty, wash it with cold or lukewarm water. Do not use
detergent, scouring pads, chemically treated dust cloths, gasoline, benzene,
thinner or other solvents, as these may scratch and damage the tank and
cause water leakage
3.
When replacing the drainage tank, press the tank firmly into place with both
hands. If the tank is not positioned properly, the “TANK FULL” sensor will be
