3)
Insert theLower pipe into the base
and then fix it tightly by means of L-Bolt,
The washer should be added between the Base
view 2
and the L-Bolt (view 2)
2> Join the Mid Pipe and the Lower Pipe
together with screw. (view 2)
3>Join the Telescope Pipe and the Mid Pipe
together with screw.
(view 2)
4>Join the Heater Body and the Telescope
Pipe together, then fix them tightly with
the screw.
(view 2)
5>. According to the request of use angle,
The angle for Heater Body can be adjusted at 0
º
~22
º
( view 3.)
When doing adjusting, you should follow the three steps below (view4):
1.
First loose the bolt in the joint with a screwdriver,(see step1)
2.
Take the linker by the hand and turn it up or down as you want,(see step2)
3.
Tighten the bolt again with the screwdriver.(see step3)
Warning: Always remember
you have to wait for 15 minutes after the
appliance has been switched off before changing the tit angle of the heater
Summary of Contents for THS-2000
Page 24: ......
