13
© Wilks-USA
TX750 / TX750i
Storage
Winter and Long Term Storage
If the engine is not to be used or is to be stored for more than one month the following storage procedure
should be carried out:
1. Drain all the fuel from the fuel tank and the carburettor. Ensure that all fuel has been removed.
2. Remove the spark plug and pour approximately one table spoon full of clean engine oil into the spark plug
hole.
3. With the ignition turned OFF, gently pull on the recoil starter handle several times.
4. Re-fit the spark plug and continue to pull the recoil starter handle until the piston is on the compression
stroke (when resistance is felt) then stop pulling.
5. Store the pressure washer in a dry well ventilated place under a cover to prevent any dust or debris from
accumulating on the pressure washer.
If the pressure washer is not being used for more than three months or if there is any danger of ice or frost
where the unit is stored, especially during the Winter months, certain precautions must be taken to ensure no
damage occurs to your washer or gun. Follow the previous steps for storage by ensuring there is no water left
inside the unit. The pump may require insulated protection from freezing conditions. The gun must be drained
of fluids to avoid water expansion. This will damage your gun.
