7
WaveCAST C
Power Supply Connection
Connect the TFP 062 power supply to the round Power Supply Jack located on the rear of the WaveCAST C
transmitter labelled "24VDC 0.75A".
Ethernet and Dante RJ-45 Connection
If connecting to a network or directly to a PC, a. Ethernet cable must be used. A
crossover
cable is not necessary
because the WF T5C is auto-configuring.
Audio Source Connections
The WaveCAST C transmitter will accept the following audio sources:
1� Balanced Microphone with or without 12 volt phantom power (DIN 45596) on a 3-pin (XLR) connector�
2� Balanced/Unbalanced microphone with or without phantom power on 1/4 inch (TRS) jack
3� Balanced/Unbalanced Line on a 3-pin (XLR) connector�
4� Balanced/Unbalanced Line on 1/4 inch (TRS) jack�
5� Dante on an RJ-45 jack (optional)�
WARNING:
The WaveCAST C is not designed to accept 70 volt speaker signals! This may result in damage to your
system� The sound source should come directly from the system mixer or digital source as a low-level or
unprocessed signal�
IMPORTANT: When a suitable audio source has been determined, you MUST configure the audio source in
the menu of the WaveCAST C before plugging that source in�
IN PHASE
FROM MICROPHONE
1
2
3
3 PIN CONNECTOR
BALANCED LINE/LOW IMPEDANCE MICROPHONE
A104
UNBALANCED LINE USING 3–PIN CONNECTOR
1
2
3
3 PIN CONNECTOR
A105
BALANCED LINE USING 1/4" CONNECTOR
IN PHASE
A106
UNBALANCED LINE USING 1/4" CONNECTOR
A107
4.7 K
4.7 K
SOURCE A
SOURCE B
CONNECTING TO A MULTI-CHANNEL OR STEREO SOURCE
A109
Multi-Channel Sources
By constructing a simple resistive mixer, stereo (or 3 channel) sources can be connected to the WaveCAST C.
Additional channels can be accommodated by adding a resistor for each source.
Note: The Dante audio input will automatically mix the left and right channels.
