Page
3
of
4
Assembly Instructions:
Configuration #1: Livingston Single Drawer Pedestal (A) or Double Lateral File (B) and Livingston Single
Top (C) or Double Top (D).
To install the Livingston Drawer Pedestal (A) or Double Lateral File (B) with the Tops (C and D), please follow the
assembly instruction which is come with the Livingston Single or Double Top (C and D).
Configuration #2: Livingston Single Drawer Pedestal with Single Top (C) and Livingston Double Lateral File
with Double Top (D)
1. Open the upper drawer of the cabinet, push the fin of the Anti-Tip Interlock pre-attached on the cabinet as
shown in
fig. 1, illustration. 1
, then open the lower drawer as shown in
fig. 2
.
2. Use Drill Bit (H) to penetrate the pre-drilled holes on the side panels of the cabinet for inserting Bolts
Connector (G) as shown in
fig. 2, illustration 2
.
3. Insure all items which will be set up together have the same level. If not please adjust the levelers found on
the bottom of the furniture as shown in
illustration. 3
. Carefully grasp one side of the furniture and elevate it
slightly to provide access to levelers. Turn the leveler until adequate contact will be made with the floor.
Carefully set the furniture down. Repeat until the furniture sits level and stable.
Fig. 1
Illustration. 1
Fig. 2 Illustration. 2
Illustration. 3
