Installation Guide & User Manual
PhoneMax
®
Model TEL 030
6
Installation Steps
Step 1: Make sure you have a telephone jack within 6 feet of the
place you’ve chosen to install the PhoneMax. If you have
an older 4-prong jack, you’ll need a modular jack adapter.
These adapters are available from electronic, phone, and
other retail stores.
Step 2: Place the Pulse/Tone Switch, located on the side of the
phone, in either Tone or Pulse (Rotary Dial Pulse).
Make
sure you choose the correct dialing mode. Tone dialing
will not work if you have only dial pulse (rotary) service.
Step 3: Set Ringer Volume and Tone Controls to desired level.
(see
Fig.3)
Step 4: Plug the coiled handset cord into the handset. Plug the
other end into the telephone base.
(see Fig. 4)
RINGER
OFF
LO
HI
RINGER TONE
I
II
III
Ringer Tone Control
Adjusts ringer pitch (I, II, III)
Ringer Volume Control
Adjusts ringer volume (Hi, Lo, Off)
Fig. 3: Ringer Controls
Fig. 4: Handset Connection
PULSE TONE
TO TEL. LINE
Pulse / Tone Switch
Switches between touch-tone
and rotary dial modes.
Fig. 2: Pulse/Tone Switch
