9
PhoneMax
®
Model TEL 030
Installation Guide & User Manual
Bare Wall Installation
Even if you don’t have a studded wall phone plate, you can still mount
the PhoneMax on any wall surface within six feet of a standard modu-
lar jack. To mount the phone farther from the jack you’ll need a lon-
ger line cord or a telephone extension cord.
Step 1: Measure and mark the wall for mounting screws.
Mark two points 4.0 inches apart for upper and lower
mounting screws. The lower mark should be 48–52 inches
from the floor. Use a level to make sure the marks are
aligned vertically.
Step 2: Install the mounting screws (not included).
Use wood screws for stud mounting, anchor screws for hol-
low wall mounting. Drive the screws almost completely in,
leaving a
1
⁄
8
(0.125) inch space between the wall surface and
the bottom of the screw head (about the thickness of two
stacked pennies).
Step 3: Rotate the handset hanger to prevent the handset from fall-
ing.
(see Fig. 6)
Step 4: Mount the Phonemax.
Hang the telephone on the mounting screws and push down
gently until it snaps into place
Step 5: Connect the line cord to the jack on the top of the phone.
Plug the other end of the line cord into a modular wall jack.
Make sure it snaps firmly into place.
Step 6: Check for the dial tone.
If you can’t hear a dial tone, see
In Case Of Difficulty, page
12
.
Note: To disconnect the telephone, squeeze the clip on the modu-
lar plug and pull it out of the jack.
