PLA DL210NET Digi-Loop™ DSP Induction Loop Amplifier
28
PC APP MAIN SCREEN
Mix Gain
- Allows an additional point of control to mix individual inputs as required for each output. (Click on the dial, then slide up/
down to adjust)
Line/Mic/Phantom Mic Select
- Switches between a Line-level signal, dynamic microphone or 48v condenser microphone.*
Input Trim
- Provides fine trim of the input gain.
Input Effects/Output Effects
- Opens the Input or Output Effects adjustment window (see Figures M,N).
Input/Output Mute
- Mutes the Input or Output without the need to use the slider control. Unmute returns to slider gain level.
Input VU Meter/Output VU Meter/Loop Output VU Meters
- Shows the active level of the audio post-adjustment.
Input/Output Gain
- Gain adjustment slider control.
Custom Input/Output Name
- Provides the ability for a custom name. The jack label is preserved above the custom name.
Loop Modes
- Changes the internal configuration of the amplifier to drive the load(s) chosen. Use “Dual Loop” mode for a single loop.
Input/Output Overload Indicators
- This light will turn red once an overload condition is reached. It remains red until cleared. Clear
the overload indicator by clicking on it.
Status Message Area
- If the amplifier encounters error conditions, a specific message will be displayed in this area, i.e. if a loop is
open.
Figure L: PC App Main Screen
Output
Effects
A461
Output
Mute
Input
Mute
Input
Effects
Custom Input
Name
Custom
Output
Name
Input Trim
or ‘Mic Gain’
Line/
Mic/
Phantom Mic
Select
Input
VU Meter
Mix
Gain
Loop
Modes
Loop
Output
VU Meters
Overload
Indicators
Output
VU Meter
Output
Gain
Status Box
Input
Gain
*Caution! It is very important to make sure the appropriate input configuration is set BEFORE plugging the source into the
Input 1 or Input 2 jacks.