WILLIAMSWARN BrewKeg10, User Manual

5

BREWING INSTRUCTIONS

12. 

Remove any pressure in the vessel by pressing 
the button on the VPRV. Remove lid, sediment 
bottle and drain BrewKeg10

TM

. 

13. 

Rinse sediment bottle in cold water thoroughly. 

14. 

Rinse lid in cold water and place upside down 
on bench. 

15. 

Open butterfly valve and rinse out BrewKeg10

TM

again to remove all the detergent residue. 

16. 

Close butterfly valve. 

17. 

Fill BrewKeg10

TM

 with 4L (1 gal.) of boiling water. 

18. 

 Install lid with silicon seal properly and shake 
upright, inverted and on its side for at least 
10

 seconds. 

19. 

Connect CO

2

 briefly to pressurise if required 

before connecting beer tap lines to flush 
with remaining boiling water from inside the 
BrewKeg10

TM

. (Run through beer lines until it 

runs hot). 

20. 

Remove any pressure in the vessel by pressing 
the button on the VPRV. 

21. 

Remove lid and place upside down on bench 
before draining the BrewKeg10

TM

.

Fig 2: Assembled BrewKeg

TM

 Lid

BEVERAGE-OUT PORT 
(WITHOUT NOTCHES 
ON ITS BASE HEX, WITH 
TUBE EXTENDING INTO 
THE VESSEL)

BREWKEG

TM

 LID.

GAS-IN PORT 
(WITH NOTCHES 
ON ITS BASE HEX)

‘L’ IS FOR LIQUID OUT. 
THE BLACK DISCONNECT 
CONNECTS TO IT

‘G’ IS FOR GAS IN. 
THE GREY DISCONNECT 
CONNECTS TO IT

VARIABLE PRESSURE 
RELIEF VALVE (VPRV)