CAUTION! – ALWAYS UNPLUG YOUR TREE FROM
ITS POWER SOURCE BEFORE ASSEMBLING OR
DISASSEMBLING.
ASSEMBLY:
Note: Before you start to assemble your tree please choose a location near an electrical wall outlet. Place the
tree stand on a level surface.
Please remove protective covers from the base of the pole for each tree section before assembling.
1.
Unfold the tree stand and insert the screw into the hole.
2. Carefully insert the bottom section (D) of the tree into the tree stand and tighten the screw. (See Fig. 1)
3.
Insert the lower middle section (C) of the tree into the bottom section (D). Rotate the lower middle section
(C) right or left until it falls into place, then insert vertically and tightly into the bottom section (D) to
ensure proper circuit connection. (See Fig. 2)
4.
Insert the upper middle section (B) of the tree into the lower middle section (C). Rotate the upper middle
section (B) right or left until it falls into place, then insert vertically and tightly into the lower bottom
section (C) to ensure proper circuit connection. (See Fig. 3)
5.
Insert the top section (A) into the upper middle section (B). Rotate the top section (A) right or left until it
falls into place, then insert vertically and tightly into the upper middle section (B) to ensure proper circuit
connection. (See Fig. 4)
Note: There is a tree top connector on the top section (A).
6.
Connect the end connector of power cord (E) with the connector found on the bottom section (D). It is
important that this connection is made in correct direction (always match the protuberance of the end
connector of power cord to the concave of the connector found on the bottom section (D) according to the
magnified drawing on fig. 5.
7.
Plug well-connected power supply cord from bottom section (D) into electrical outlet. (See Fig. 8)
8.
Unplug the cord when not in use.
9.
For your convenience, it is equipped with a foot pedal switch for choosing different functions.
10.
This tree is Color Changing.
1)
Press the foot switch for less than two seconds to select from the 8 lighting functions listed below:
i.
Steady Warm White
ii.
Flashing Warm White
iii.
Slow Fade Warm White
iv.
Steady Multicolor
v.
Flashing Multicolor
vi.
Slow Fade Multicolor
vii.
Sequential Multicolor & Warm White
viii. Slow Fade Multicolor & Warm White
2)
Press the foot switch for more than two seconds to select below timer hours:
i.
Indicator lights on foot switch turn on red:
The tree lights will automatically run through a 6-hours ON, 18-hours OFF cycle.
ii.
Indicator lights on foot switch turn on green:
The tree lights will automatically run through an 8-hours ON, 16-hours OFF cycle.
iii.
Indicator lights on foot switch turn on blue:
The tree lights will automatically run through a 2-hours ON, 22-hours OFF cycle.
iv.
Indicator lights on foot switch turn on yellow:
The tree lights will automatically run through a 4-hours ON, 20-hours OFF cycle.
