WH-2400 SERIES
PATIENT CARE UNITS
INSTALLATION & OPERATION MANUAL
PAGE
8
© Rev.
2/2017
1.800.428.4065
TOLL FREE
| www.willoughby-ind.com
INSTALLATION INSTRUCTIONS
Step 1: Unpacking the Patient Care Unit
1.) Remove the packaging around the unit.
2.) Locate wall and fl oor mounting templates (skid will be marked) and set aside.
(DO NOT DISCARD)
NOTE: Templates are not to be installed as part of the cabinet. They are only used to
specifi y rough-in measurements.
Step 2: Install the Anchors and Backing
1.) Select the location where the WH-2400 is to be installed. Using the supplied templates, mark
all mounting and rough-in locations.
2.) Remove the templates.
3.) Install appropriate fl oor anchors to mount the toilet Z-clip securely to the fl oor (hardware
supplied by installer).
4.) For wall outlet toilets, install the appropriate fl oor anchors in the specifi ed locations.
NOTE: If the fl oor concrete is lightweight or less than 4” thick, through-bolting to steel
angles under the fl oor is recommended (hardware supplied by installer).
5.) Install adequate backing for mounting the cabinet securely to the wall.
NOTE: Adequate backing and mounting hardware by others.
6.) Install (3) Z-clips to the wall backing. Use template to determine locations.
