WILSON AUDIO Sasha DAW, Installation And Care Manual

26

Sa sha DAW I n stal l ation and Car e

 G u ide

A u t h e n t i c   E x c e l l e n c e ™

2.  Make sure that you are in your intended listening position. 

3.  While sitting, have someone measure your ear height from the floor directly 

below your ear canal. You should be relaxed in your chair, as you would be when 
listening to music (see graphic above).

4.  Now measure the distance (on the floor) from the point on the floor below your 

ear to the base of the loudspeaker, as shown in graphic above.

5.  Refer to the Propagation Delay Tables and locate the corresponding ear height 

A u t h e n t i c   E x c e l l e n c e ™

e

ar

 H

eiGHt

 (M

eaSUred

froM

 f

loor

)

l

iSteninG

 d

iStance

 (M

eaSUred

on

 f

loor

)

S

e c t i o n

 2 . 4 —m

o U n t i n g

t h e

 U

P P e r

 m

o D U l e

27

for each module. There are two charts for the positioning of 
the Upper Module. The first: “Sasha DAW Spike Length” is a ta-
ble determining the rear spike length. The Second, “Sasha DAW 
Alignment Block Step,” specifies the step on which the rear 
spike will rest. 

6.  Make a mark on the chart Number 1 “Sasha DAW Upper Module 

Spike Length” indicating the proper rear spike for this module 
as determined by the ear height and distance from listening 
position. 

Note: The shortest spikes (labeled AA) are always used at the front of the 
Upper Module.

7.  Make a mark on the second chart labeled “Sasha DAW Upper 

Alignment Block Step” indicating Upper Module spike’s resting 
position on the alignment block. Set this information aside as 
you will refer to it in the next section. (See Section 5.)

Section 2.4—Mounting the Upper Module

Materials Required:

1.  Correct spikes for the upper module. 

2.  Section 5 shows the use of the proper length of rear spike of 

W i l s o n   A u d i o   S p e c i a l t i e s