INDUSTRIAL CLASS IN-BUILDING CELL SIGNAL AMPLIFIER
PRO 710i
12
Model Number
460064
FCC ID
PWO460064
IC ID
4726A-460064
Connectors
N-F
emale
Antenna Impedance
50 Ohms
Max Gain
85 dB
Frequency
617-652 MHz, 663-698 MHz
Power output for single cell
phone (Uplink) dBm
600
MHz
Band 71
24.2
Power output for single cell
phone (Downlink) dBm
600
MHz
Band 71
24.5
Noise Figure
5 dB nominal
Isolation
> 90 dB
Power Requirements
120V AC 0.5A
Each Signal Booster is individually tested and factory set to ensure FCC compliance. The Signal Booster cannot be
adjusted without factory reprogramming or disabling the hardware. The Signal Booster will amplify, but not alter
incoming and outgoing signals in order to increase coverage of authorized frequency bands only. If the Signal Booster
is not in use for five minutes, it will reduce gain until a signal is detected. If a detected signal is too high in a frequency
band, or if the Signal Booster detects an oscillation, the Signal Booster will automatically turn the power off on that
band. For a detected oscillation the Signal Booster will automatically resume normal operation after a minimum of 1
minute. After 5 (five) such automatic restarts, any problematic bands are permanently shut off until the Signal Booster
has been manually restarted by momentarily removing power from the Signal Booster. Noise power, gain, and linearity
are maintained by the Signal Booster’s microprocessor.
This device complies with Part 15 of FCC rules. Operation is subject to two conditions: (1) This device may not cause
harmful interference, and (2) this device must accept any interference received, including interference that may cause
undesired operation. Changes or modifications not expressly approved by Wilson Electronics could void the authority
to operate this equipment.
Specifications
B7
1
Outside antenna maximum permissible
antenna gain (dBi) 50Ω
6.5
Inside antenna maximum permissible
antenna gain (dBi) 50Ω
6.0
Antenna
This radio transmitter has been approved by
the FCC and
Innovation, Science and Economic Development
Canada to operate with the
maximum permissible antenna gain be
low
.
Antenna that have a gain greater than
the maximum gain indicated for any type listed are strictly prohibited for use with this device.
Specifications
