7
Contact Wilson Electronics Technical Support Team with any questions at 866-294-1660
or email: tech@wilsonelectronics.com. Hours: 7 am to 6 pm MST.
8
Powering up a Wilson Electronics Signal Booster
1.
IMPORTANT!
Ensure that all cell phones and cellular data cards within 50 feet of the
Inside Antenna are turned off.
2. To verify proper installation of the Signal Booster and antennas, make sure that the
distance between the Inside and Outside Antennas is a minimum of 50 feet for the 50 dB
Signal Booster, 68 feet of separation distance for the 60 dB PCS Signal Booster, and 75
feet for the 65 dB cellular Signal Booster.
3. If you are using an outside Yagi Antenna, never point the front of the Yagi toward the
Inside Antenna.
4. Ensure that both the Outside Antenna cable and the Inside Antenna cable are connected
to the Signal Booster before powering up the Signal Booster.
5. Plug the power supply into the Signal Booster input marked “POWER” (carefully, to avoid
damaging the center pin) and then into a AC Power Strip.
NOTE: The aluminum casing of a Wilson Electronics Signal Booster will adjust very
quickly to the ambient temperature of its environment. For example, in the
summer, when the attic of a house can easily exceed 140 degrees Fahrenheit,
the Signal Booster temperature may be 10 or more degrees higher. The casing
will be hot to the touch. Such high temperatures will not damage the Signal
Booster, nor do they pose a fire risk. As recommended in these instructions,
install the Signal Booster in a location with adequate ventilation. Keep the area
free of items that could block air flow to the Signal Booster.
Warning:
Use only the power supply provided in this package. Use of a non-Wilson
Electronics product may damage your equipment (power supply sold
separately in 801175).
Warning:
Verify that both the Outside Antenna and the Inside Antenna are connected
to the Signal Booster before powering up the Signal Booster.
IMPORTANT NOTICE
It is very important to power your Signal Booster using a
•
surge protected AC Power Strip with at least a
1000 Joule
rating.
Failure to do this will void your warranty in the
•
event of a
power surge or lightning strike.
