6
WARNINGS AND RECOMMENDATIONS
Warning:
Do not plug in the DC plug-in power supply until the outside antenna cable is attached to
the amplifier.
Warning:
RF Safety:
The C-Booster
™
cradle/amplifier must be installed with a separation of at
least 8 inches from all persons and must not be located in conjunction with any other
antenna or amplifier.
Warning:
RF Safety:
The outside antenna must be installed with a separation of at least 8 inches
from any of the vehicle’s occupants or nearby persons and must not be located or
operating in conjunction with any other antenna or amplifier.
Separation of inside and outside antennas is very important. In a vehicle, the metal roof acts as a
barrier and helps shield the two antennas from each other, preventing oscillation.
If the vehicle has a sunroof, it is important to keep the outside antenna at least 8 inches from the edge of
the sunroof. This prevents the amplifier from oscillating.
ABOUT WILSON ELECTRONICS
Wilson Electronics, Inc. has been a leader in the wireless communications industry for nearly 40 years.
The company designs and manufactures amplifiers, antennas and related components that significantly
improve cellular telephone signal reception and transmission in a wide variety of applications, both mobile
and in-building.
With extensive experience in antenna and amplifier research and design, the company’s engineering
team uses a state-of-the-art testing laboratory, including an anechoic chamber and network analyzers,
to fine-tune antenna designs and performance. For its amplifiers, Wilson uses a double-shielded RF
enclosure and cell site simulators for compliance testing.
All products are engineered and assembled in the company’s 50,000-square-foot headquarters in St.
George, Utah. Wilson has product dealers in all 50 states as well as in countries all over the world.
*Curve is a registered trademark of Research In Motion Limited, Inc.
wpsantennas.com
1-877-594-5766
wpsantennas.com
1-877-594-5766
