3
EN
The volume, crossover frequency and phase can be adjusted on the subwoofers rear panel
(controls 1,2 and 3) and we recommend that you adjust the setting of these controls to your
own personal liking – you can try with different music and films.
We do not recommend use of any solvents or cleaners on the WILSON SUB-10 cabinet,
the cabinet surface only requires dusting or cleaning with a damp soft cloth (use cold
clean water). Avoid touching the drive unit, and do not use the subwoofer as a flower,
coffee or drinks table (risk of water or liquids being spilled into the subwoofer).
We recommend that you disconnect the subwoofer from the mains supply if taken out of
use for a longer period.
Setting volume, frequency and phase
Care and cleaning
Troubleshooting
If no sound, check:
●
that the subwoofer is turned on (indicator LED lamp glows)
●
that the VOLUME control (1) on the rear panel is not turned down to zero (MIN)
●
that the input cable (10) is connected properly to both subwoofer and amplifier
●
that the subwoofer gets a signal from the amplifier - check tone on most av-receivers
LED indicator lamp does not light up, check:
●
that the power cord (6) is firmly plugged into the wall outlet
●
that the POWER switch (4) is ON
●
that the mains voltage is correct and matching the subwoofer
●
the fuse, if fuse (8) need to be replaced only use same type and value.
IMPORTANT; unplug the subwoofer from the mains outlet before checking the fuse.
WILSON SUB 10
Subwoofer
(EN) SPECIFICATIONS
*SPECIFICATIONS
Type: Active Subwoofer, bassreflex system
Driveunit: 1 x 10” (250mm) long throw subwoofer
Inputs: RCA stereo input
Mains voltage:
AC 230V/50Hz
Phase switch: 0/180 degrees
Volume:
adjustable
controlFrequency Response: 25 – 150 Hz
Crossover Frequency: adjustable
Output Power: 150W
Weight:
11.6 kg
Dimensions: 320x320x336mm (HxWxD)
*Specifications are subject to change without notice.
