IN-BUILDING CELL SIGNAL AMPLIFIER
ENTERPRISE 1300 & 1300R
34
If you need to modify the amplifier communication settings, this utility was created to
help you. The default setting is Ethernet Preferred (gives priority to Ethernet, but will
switch to LTE if Ethernet is not connected).
NOTE: It is only necessary to use this utility if you wish to CHANGE a communication
setting. The default setting of Ethernet preferred, LTE backup, is almost always the
best setting to use.
Cat 5/6 cable
If the Installer/Integrator wishes
to change this setting, a laptop
computer must be connected to the
1300/1300R via a Cat 5/6 cable to the
Ethernet port on the amplifier.
After connecting, the network icon on
the amplifier will change color from red
to yellow after about one minute.
Local Amplifier
Configuration Utility
