Description
WDC-300 provides two modes to measure feature, Forward annotation measurement
and backward annotation measurement. Because of different operation and message
showing method between these two mode, we will show you how to measure feature
respectively.
5.1 M
EASURING POINT FEATURE
a. Forward Annotation Mode
Operating steps:
1. Return normal monitor state;
2. Press
POINT
, then "Probe Point n" is displayed in the message window
(n is a number), which indicates that WDC-300 is waiting for next point to be
sampled;
3. Moving the linear scale to the measuring point, press
ENTER
, then "
n
More Points" is
displayed in the message window (
n
is a number, it will minus by 1 automatically
after pressing
ENTER
every time);
4. Repeat step 3, during this operation, press
CANCEL
to delete the last entered point
or press
POINT
to add a new point;
5. The measurement will be ended automatically when the sampled point number
reaches the number needed, at the same time, "a0 Point X/Y" is displayed in the
message window, the X coordinate of this point feature is displayed in the X
window, the Y coordinate of this point is displayed in the Y window.
Note:
(1)
Press
QUIT
to quit the operation.
(2) The number
n
in step 2 can be set up in interior setting (please refer to 7.10).
(3) Press
POINT
more times will increase the number of sample points for point feature.
(4) Press
FINISH
to end the operation.
b. Backward Annotation Mode
Operating steps;
1. Return normal monitor state;
2. Press
POINT
, then "Point 01" is displayed in the message window, which indicates
that it is waiting for the points to be sampled;
3. Move the linear scale to the measuring point, press
ENTER
, then "Point
n
" is
displayed in the message window (
n
is a number, it will plus by 1 automatically
after pressing
ENTER
each time);
4. Repeat step 3, during this operation, press
CANCEL
to delete the last sampled
point ;
5. Press
FINISH
to end the measurement when the sampled points number is
enough, at the same time, "a0 Point X/Y" is displayed in the message window, the
X coordinate of this point feature is displayed in the X window, the Y coordinate of
this point feature is displayed in the Y window.
Note:
(1) Press
QUIT
to quit the operation.
(2) Sample mode can be set up in interior system setting (please refer to 7.9).
Manual WDC-300
21
5. M
EASURING AND CONSTRUCTING FEATURES
Summary of Contents for WDC-300
Page 1: ...Manual WDC 300 COUNTER FOR WPP 300 ...
Page 54: ...W03 134 ...
