waiting for your to input value of the first compensation point.
12. Enter the standard value of each compensation point. The number of sample points
is from 2 to 100.
13. Press
FINISH
when the entering of compensation point is finished, "Finished …" is
displayed in the message window, and program will return the
"X Compensation? " function list.
Note:
(1)
This setup can compensate the error between the measuring value and the standard value.
(2) In nonlinear compensation mode, user must setup up nonlinear compensation parameters.
(3) If you want to set up the compensation value of Y-axis, in step 8 Press or to browse function list until "Y
Compensation ? " is displayed in the message window;
(4) When you input the compensative value of one certain point, you must select the sample points from one
port to another of the axis in sequence, and it is best that its direction is the same as the count direction of
the axis.
7.20 S
ETTING UP TO LOCK OR UNLOCK THE USER PROGRAMS
Example:
Lock the user programs
Operating steps:
1. Enter setup status;
2. Press
or
to browse function list until "Super…" is displayed in the message
window;
3. Press
ENTER
, then "Password:" is displayed in the message window;
4. Enter password correctly; password: 332
5. Press
ENTER
, now user enter super setup;
6. Press
or
to browse function list until "Prog Lock:NO" is displayed in the
message window;
7. Press
ENTER
, then "Prog Lock:YES" is displayed in the message window, which
mean that the user programs is locked.
Note:
(1)
After the user program is locked, the user programs can't be recorded and edited, you can only view or run
the programs.
(2) Unlock the user program:
1.
The 1-5 steps are the same as the lock steps.
2.
In step 6, the display of message window is "Prog Lock: YES".
3.
In step 7, press CANCEL, then "Prog Lock:NO" is displayed in the message window, which means that
the user programs is unlocked.
7.21 S
ETTING UP THE PRESCALE COEFFICIENT
Example:
set up the prescale coefficient equal to 1.00005
Operating steps:
1. Enter setup status;
2. Press
or
to browse function list until "Super…" is displayed in the message
window;
3. Press
ENTER
, then "Password:" is displayed in the message window;
4. Enter password correctly;
5. Press
ENTER
, now user enter super setup status;
6. Press
or
to browse function list until "Prescale" is displayed in the message
window;
7. Press
ENTER
, then "Value: 1. 000000" is displayed in the message window;
8. Press
1 . 0 0 0 0 5
in turns to input data 1.0005;
9. Press ENTER, confirm 1.0005 is the right value, then the system return the
"Prescale? " function list.
Manual WDC-300
43
Summary of Contents for WDC-300
Page 1: ...Manual WDC 300 COUNTER FOR WPP 300 ...
Page 54: ...W03 134 ...