Description
1. Special key
Special key are the keys, which cannot be inputted from the panel when user create
or edit user program. For instance, when user program is edited, it needs inputting
QUIT in the middle of the key series, if the QUIT is inputted from the keypad, it will
result in quitting the user program edition instead of inputting QUIT successfully.
2. Special key options
(1)
Finish Record
It indicates that the inputted user program is accepted, a
new user program is created at the same time and
WDC-300 exits the user program create state.
(2)
Quit Record
It indicates the user program inputted is not accepted, a
new user program is not created and then WDC-300 exits
the user program creating state.
(3)
Run Prog
It indicates another user program is invoked by the
current user program.
(4)
Finish
It indicates
FINISH
key is inserted before the current
editing position.
(5)
Quit
It indicates
QUIT
key is inserted before the current editing
position.
(6)
Cancel
It indicates
CANCEL
key is inserted before the current
editing position.
(7)
Up
It indicates a
is inserted before the current editing
position.
(8)
Down
It indicates a
is inserted before the current editing
position.
(9)
Wait Enter
It indicates a state waiting for
ENTER
to be inputted from
the panel, and the state is inserted before the current
editing position.
(10)
Wait Finish
It indicates a state of waiting for
FINISH
to be inputted
from the keypad, and the state is inserted before the
current editing position.
Note:
1. (1), (2) and (3) of Special Key options are used in creating new user program, (3), (4), (5), (6), (7), (8), (9) and (10)
are used to edit user program.
2.
(9) and (10) are only used to edit user program which are relative to the measuring operation.
3.
User must return to the normal monitor states when the special key (3) is selected.
8.1 C
REATING USER PROGRAM
Example 1:
Create the 0th user program to accomplish the following functions.
This example will show you how to create a program which measure a point feature
with "n" points. ("n" is a numeric number, if use of forward annotation format, to set n
value in internal system, if use of backward annotation also set n value in internal
system)
46
Manual WDC-300
8.
C
REATING
,
RUNNING AND EDITING USER PROGRAM
Summary of Contents for WDC-300
Page 1: ...Manual WDC 300 COUNTER FOR WPP 300 ...
Page 54: ...W03 134 ...