background image

  

© by WilTec Wildanger Technik GmbH  

 

Seite 14  

http://www.WilTec.de 
http://www.aoyue.eu

 

Version 3.2016

 

http://www.teichtip.de 

 

 SAFETY GUIDELINES

 

 

 

The user should choose the right compressor with the appropriate air volume and air pressure 
to correspond to the actual work requirements. 

 

Never expose the  device to dust, acid, steam, explosive or flammable gases or atmospheric 
influences (rain, sun, fog, snow). 

 

The vacuum pump can be operated only in an appropriate environment (well ventilated, ambi-
ent tempe5 - +40 degrees C). 

 

Never use the compressor barefoot or with wet hands or feet. 

 

Never allow children to touch the switched-on compressor or to insert the plug. It may cause 
burns or electric shocks. 

 

Do not open or damage any part of the compressor. If necessary please contact your seller. 

 

Release the water by opening the drain valve. Always do so before not using the compressor 
for a long time. Store the compressor in a well ventilated place. 

 

Always  wear  goggles.  Under  no  circumstances  should  you  direct  the  airflow  towards  your 
body or other persons’ bodies. 

 

Never use in areas with steam or moisture or close to water. 

 

Switch  off  the compressor  if  you  do  not  use  it.  Disconnect from mains  before  you  repair,  re-
condition, maintain,  clean  or  replace  parts.

 

Never  use  the  power  cable  as  handle.  Keep  the 

power cable away from hot objects, oil and sharp edges. Protect it against breakage. Do not 
pull the power cable in order to unplug it from the power socket.

  

 

If the compressor is used outdoors

only approved extensions may be used

Every wire of the 

extension cable must have at least 1, 5 mm

2

 cross- section. 

 

Do not store the compressor with the plug inserted into the plug. Do not allow children or any 
other people who are not able to handle this device to play or work with it. 

 

Be very careful when you are working with the compressor. Do not use it if you are tired. Per-
sons under the influence of alcohol, drugs or medication are not allowed to use this device. 

 

When you start working make sure that all screws are tightened. 

 

Do not use the compressor if it is damaged. If the compressor generates unusual noises and 
strong vibrations  or

 

if  other  unusual  signs  occur  that  indicate  some  damage  you  should  turn 

off the compressor immediately. For repairs please use only original spare parts. Do not make 
any  technical modifications  to  the  compressor.  In  case  you  cannot  eliminate the malfunction 
hand over the device to your seller

 

Sie das Gerät Ihrem Verkäufer. 

 

Properties 

1. 

Compressor with pressure regulator, condensate drain and manometer 

2. 

Oil free, piston compressor, no polluted air 

3. 

With water filter, pressure adjustment and manometer 

4. 

Overtemperature protection 

5. 

Very low noise level 

 
 

Field of application 

The AF18-2 Airbrush compressor is among others suitable for the operation in the following areas: 
Crafts, hobby, modelling, tattoos and body art, make-up and nail design, as a source of air in the med-
ical field, food and chemical industries, laboratories etc. 
 
 

 

Summary of Contents for 34203









Reviews: