Warning!
A potential hazard that could cause serious injury or loss of life:
Do not weld on the air tank of this compressor. Welding on the air compressor tank can cause
an extremely hazardous condition. Welding on the tank in any manner will void the warranty.
Never use an electric air compressor outdoors when it is raining or on a wet surface, as it may
cause an electric shock.
This unit starts automatically.
Always
turn the compressor off, remove the plug from the out-
let, and release all pressure from the system before servicing the compressor, and when the
compressor is not in use.
Check the manufacturer’s maximum pressure rating for air tools and equipment. The com-
pressor outlet pressure must be regulated to never exceed the maximum pressure rating of
the tool.
High temperatures and moving parts are located under the guard. To prevent burns or other
injuries, do
not
operate with the guard removed. Allow the compressor parts to cool before
handling or servicing them.
Be certain to read all labels when you are spraying paints or toxic materials and follow the
safety instructions. Use a respirator mask if there is a risk of inhaling anything you are spray -
ing. Read all instructions and be sure that your respirator mask will protect you.
Always wear safety goggles or glasses when using an air compressor. Never point any nozzle
or sprayer toward a person, an animal or any part of the body.
Do not adjust the pressure switch or regulating valve for any reason. Doing so voids all war-
ranties. They have been pre-set at the factory for the maximum pressure of this unit.
Caution!
A potential hazard that may cause moderate injury or damage to equipment:
Drain the moisture from the tank on a daily basis. A clean, dry tank will help prevent corrosion.
Pull the pressure relief valve ring daily to ensure that the valve is functioning properly and to
clear of any possible blockages.
To provide proper ventilation for cooling, the compressor must be kept a minimum of 31 cm
(12 inches) from the nearest wall and in a well-ventilated area.
Fasten the compressor down securely if transport is necessary. The pressure must be re-
leased from the tank before transport.
Protect the air hose and electrical wire from damage and puncture. Inspect them weekly for
weak or worn spots, and replace them if necessary.
Warning:
Disconnect power and release all pressure from the system before attempting to install, ser-
vice, relocate or perform any maintenance.
Follow all local electrical and safety codes as well as National Electrical Codes (NEC) and Oc-
cupational Safety and Health Act (OSHA).
Electric motors and starters must be securely and adequately grounded using a three-pronged
outlet.
Caution:
Never use an extension cable with this product. Use an additional air hose instead of an ex -
tension cable to avoid power loss and permanent motor damage. Use of an extension cable voids the
warranty.
Brief Description
This micro air compressor is of novel design and excellent workmanship. Having the advantages of
compact construction, fine design, light weight, easy operation, high safety and low noise, it can be
widely used in machinery, chemical industry, spray and decoration, automatic control system and
other fields where compressed air is required.
© by WilTec Wildanger Technik GmbH
Item 61016
Page 4
http://www.WilTec.de
http://www.aoyue.eu
11 2020
-1
