AIR SUPPLY AND CONNECTIONS
Do not use any type of reactive gases like oxygen carbon dioxide and combustible gases as a
power source. Use filtered, lubricated, regulated compressed air only. Use of a reactive gas in-
stead of compressed air may cause the tool to explode which will cause death or serious personal
injury.
Use only a pressure-regulated compressed air source to limit the air pressure supplied to the tool.
The regulated pressure must not exceed 90 PSI. If the regulator fails, the pressure must not ex-
ceed 90 PSI. The tool could explode which will cause death or serious personal injury.
Always disconnect air source:
o
Before making adjustments
o
When servicing the tool
o
When tool is not in use
o
When moving to a different work area as accidental actuation may occur causing injury
Never connect the tool to an air source that may exceed 90 PSI. Over pressurizing the tool may
result in bursting, abnormal operation, breakage of the tool as well as serious personal injury. Use
only clean, dry, regulated compressed air at the rated pressure or within the rated pressure range
as marked on the tool. Always verify prior to using the tool that the air source has been adjusted to
the rated air pressure or within the rated air-pressure range.
SPECIFICATIONS
Square drive:
1/2”
Idle speed:
7000 rpm
Max torque:
230 ft-lb
Air consumption:
5 cfm
Air inlet:
1/4”
Max air pressure:
90 psi
Accessories:
1x 5/32” hex key
Oil bottle
© by WilTec Wildanger Technik GmbH
Seite 22
http://www.WilTec.de
http://www.aoyue.eu
http://www.teichtip.de
