Introduction
Thank you for purchasing this quality product.
To minimize the risk of injury we urge that our cli-
ents take some basic safety precautions when using this device. Please read the operation in-
structions carefully and make sure you have understood its content.
Keep these operation instructions safe.
Safety notes
Read all safety notes and instructions and make sure that you have understood them. Non-
compliance with the instructions can lead to serious injury. Keep the operating manual for fu-
ture reference.
Keep the work area clean and well lit. Cluttered workbenches and dark or untidy areas invite
accidents. Keep bystanders and children away when operating the tool. Distractions can lead
to a loss of control. If required, keep barriers or shields ready.
Ensure that the tyre changer is placed on an even and solid surface, which is able to hold the
weight of the device including the tyre and other equipment used.
Do not let children or other unauthorised people operate the tyre changer or play with it.
Do not operate the tyre changer with force. The device will operate safer and better, if it is op-
erated with the speed and capacity it is designed for.
Read and follow all safety notes and instructions, which can be found in the manuals of the
tyre manufacturers before operating the tyre changer.
Use the right tools for the individual tasks needing to be carried out. Do not try to use a smal-
ler tool to carry out the work of a bigger industrial tool. There are specific purposes for which
this tool has been designed. It will carry the work out better and in a safer speed, when used
as designated. Do not modify this device in any way and do not use it for anything else other
than its intended purpose.
Be careful at all times. Pay attention to what you are doing and be cautious when using tools
and machinery. Do not use tools and machinery if you are tired or under the influence of alco -
hol, drugs or medicaments which can affect your consciousness.
A short moment of inattentiveness when handling a tool or machinery can lead to serious in-
jury.
Wear adequate clothing. Do not wear any loose clothing or jewellery. Tie long hair together.
Do not lean over too far. Make sure you have a stable stand and can keep your balance at all
times. A secure positioning and keeping balance allow better control over the device in unex-
pected situations.
Use a protective gear. Wear protective glasses and full-face protection when assembling or
operating the device.
Examine the tyre changer before every use. Check for loose screws, misalignment or jammed
moving parts, etc. Also check for torn or broken parts and whether unusual noises or vibra -
tions occur. Have any problems checked and if necessary repaired before operating the
device again. Do not use damaged devices.
Quad and ATV tyres
Note:
Quad/ATV tyres are more difficult to mount and demount due to their small diameter.
But also, the tyres are soft and bend easily when pressing the side walls slightly.
If the bead breaker
(10)
slips off the tyre, hold it in its place and work your way around the rim
to press the side walls down step for step.
Place lubricant between the tyre and the rim so that it can slide off easier.
If the tyre has a high rim with a small inner diameter so that the rim does not reach above the
round plate of the centre post
(1)
and cannot be placed on the spider post
(4)
or if the lug pin
(3)
runs through the hole, you should still be able to use the device to mount and dismount the
tyres. Most rims are tightened via the post cap. With the cap on, one should still be able to
hold the rim in its place to be able to mount and dismount the tyre as mentioned.
© by WilTec Wildanger Technik GmbH
Item 61309
Page 3
http://www.WilTec.de
http://www.aoyue.eu
02 2021
-1
