© by WilTec Wildanger Technik GmbH
Item 62308
Page 6
05 2021
-1
Note!
The sprayer is pre-assembled with the pump lever for left-hand and the spray gun for right-hand
use. If you want a reverse arrangement, proceed as follows:
1. Use a fitting screwdriver to lift the spray gun holder
(953)
out of its fit on the vertical part of the
joint rod.
2. Remove the metal pin
(495)
and separate fastening clip
(338)
on the bottom side of the con-
tainer from the pump lever. Use a screwdriver if necessary.
3. Pull the pump lever out of the front fit on the side of the container and insert it into the back fit.
Then reinstall the spray gun holder
(953),
metal pin
(495)
, and fastening clip
(338)
.
4. Remove the carrying belts from their fixing. Thread the belts on the opposite side of the con-
tainer in the same way. Secure the belts to the bottom of the container with the belt fixing
(318, 819)
.
