© by WilTec Wildanger Technik GmbH
Item 34201
Page 5
09 2021
-1
Technical specifications
Type
Compressor with tank and casing
Power
(W)
125 (
⅙
hp)
Rotation speed
(rpm)
1450
–1700
Flow rate
(
ℓ
⁄
min
)
20
–23
Pressure range
(
㍴
)
0
–3
Weight
(
㎏
)
2.8
Size
(
㎜
)
160×160×140
Suitable nozzles
(
㎜
)
0.2
–1.0
Capacity
(ℓ)
0.3
Sound level
(dB (A))
approx. 47
Length of cable
(m)
1.9
Hose connection
(
㎜
)
9.51 (⅛″)
User notes
•
The compressor has a 9.51
mm (⅛″) outlet with external thread which can be effortlessly
changed to ¼″. The matching adapter is not included in the delivery.
•
When the compressor is connected by the hose to the airbrush gun, it can be connected to the
mains and switched on.
•
The maximum pressure is displayed the pressure gauge, the operating pressure can be
adjusted by the pressure regulator.
•
The hose included in the delivery is air-tight. If the auto-stop mode is activated (repeatedly
switched on/off) any and all screw fittings and connections should be sealed by sealing tape.
Leakage check
•
Switch on the compressor and wait until the maximum pressure has built up and the auto-stop
function has been activated.
•
If there is no leakage, the pressure gauge should display nearly constantly the same range of
pressure.
•
A quick decrease of the range of pressure suggests that there is in fact a leakage.
•
It is of great importance to seal any leak as soon as possible in order to avoid any impact on
the capacity and efficiency of the compressor.
•
A leakage leads to the auto-stop and auto-start constantly being switched on and off.
Difference between maximum pressure and operating pressure
•
The maximum pressure is the highest possible pressure that a compressor is able to generate.
•
The maximum pressure is the pressure measured only inside the compressor itself.
•
Once the maximum pressure has been reached, the compressor switches off (auto-stop), and
as soon as the pressure starts to decrease, it switches on again (auto-start).
•
On the outlet of the compressor, there is a lower pressure. What remains is the pressure that
you actually work with. The operating pressure may vary according to the connected airbrush
gun.
