Selecting a
Power Level
Sweep Range
Selecting a power level sweep range consists of
choosing a start and stop level for the power level
sweep. The power level sweep range selection proc-
ess is identical for all power level sweep modes—
CW power sweep and step sweep frequency/step
power. You can select a power level sweep range as
follows:
Edit the current start and stop power level pa-
rameter values.
Enter new start and stop power level parame-
ter values.
Select one of the preset power level sweep
range parameters (
L1-L2
,
L3-L4
,
L5-L6
,
L7-L8
,
or
L9-L0
).
Editing the Current Start / Stop Power Levels
To edit the current power level sweep range, start
by opening either the start or stop power level pa-
rameter (in the display above,
Edit L1
opens the
start power level parameter;
Edit L2
opens the
stop power level parameter).
Edit the open power level parameter using the cur-
sor control key or the rotary data knob. When you
are finished, close the open parameter by pressing
its menu edit soft-key or by making another menu
selection.
Entering New Start / Stop Power Levels
To enter a new power level sweep range start by
opening either the start or stop power level parame-
ters (press
Edit L1
or
Edit L2
).
Enter a new power level using the keypad and ap-
propriate terminator key. When you are finished,
close the open parameter by pressing its menu edit
soft-key or by making another menu selection.
LOCAL (FRONT
POWER LEVEL
PANEL) OPERATION
SWEEP OPERATION
3-44
680XXB OM
Summary of Contents for 680 B Series
Page 5: ......
Page 11: ...Figure 1 1 Series 680XXB Synthesized CW Generator...
