This menu lets you edit the listed frequencies for
the Slave 68XXXB.
Use the cursor control key to select a frequency pa-
rameter from the list, then press
Edit
to edit its
value. Edit the current frequency parameter value
using the cursor control key or rotary data knob or
enter a new value using the key pad and appropri-
ate termination key. Press
Edit
again to close the
open frequency parameter.
When you are finished editing the slave frequencies,
press
Previous Menu
to return to the Master-
Slave menu (below).
The Master-Slave menu lets you set the dF fre-
quency and L1 and L2 power level parameters for
the Slave unit.
Press
Slave DF
to open the dF frequency parame-
ter.
Press
Slave L1
to open the main power level pa-
rameter.
Press
Slave L2
to open the alternate sweep power
level parameter.
Open the parameter you wish to change, then edit
the current value using the cursor control key or ro-
tary data knob or enter a new value using the key
USE WITH
MASTER-SLAVE
OTHER INSTRUMENTS
OPERATION
NOTE
Upon reset, the slave frequencies
(F0 - F9 and M0 - M9) return to the
default values shown here.
7-6
680XXB OM
Summary of Contents for 680 B Series
Page 5: ......
Page 11: ...Figure 1 1 Series 680XXB Synthesized CW Generator...
