This menu lets you edit the listed frequencies for
the Slave 68XXXB.
Use the cursor control key to select a frequency pa-
rameter from the list, then press
Edit
to edit its
value. Edit the current frequency parameter value
using the cursor control key or rotary data knob or
enter a new value using the key pad and approriate
termination key. Press
Edit
again to close the open
frequency parameter.
When you are finished editing the slave frequencies,
press
Previous Menu
to return to the Master-
Slave menu (below).
The Master-Slave menu lets you set the dF fre-
quency and L1 and L2 power level parameters for
the Slave unit.
Press
Slave DF
to open the dF frequency parame-
ter.
Press
Slave L1
to open the main power level pa-
rameter.
Press
Slave L2
to open the alternate sweep power
level parameter.
Open the parameter you wish to change, then edit
the current value using the cursor control key or ro-
tary data knob or enter a new value using the key
USE WITH
MASTER-SLAVE
OTHER INSTRUMENTS
OPERATION
NOTE
Upon reset, the slave frequencies
(F0 - F9 and M0 - M9) return to the
default values shown here.
7-6
681XXB OM
