WiMo EAntenna 144XLFA16, Manual

Step 1

Step 2

Step 3

M6 Ring x 50mm

SA048-9660

Wire Clamp

Boom

Boom

Guy joint in the Boom

Once done Step 1, insert the ring by screwing on the 2 threaded studs that 
are in the boom to reach the top of the upper nut. Place the other washer 
and nut with your fingers to get the most you can with your hand. After a key 
10, the first torque nut is nearer to the pin and then the bottom.
When it is finished, we continue to Step 3.

Pass the end of the rope Mastrant P5 once or twice through the hole in the 
ring and attach the cable clamp firmly with maximum pressure.
Once it is fixed, you go to Step 4 which is to place the 

EA010007D plate

, 

where the tension of the string are fixed.

To put the Tightener

 (P1500003) 

before you have to have fixed plate 

(EA010007D) 

with the U-bolt 

(A-0163) 

and tube Clamp

 (23035.50).

Once firmly attached, insert the Tightener into the hole and thread the rope through the 
ring Mastrant P5 tensioner and tightening firmly tighten the cable clamp to secure the 
rope.

Note that to tighten the rope previously have to open all the threads of the 
turnbuckles.

Step 4

For increased wind resistance, this antenna includes an anchor system for 
better conservation before the Climatological.
The plate 

(EA010007)

, must be at least 50cm apart on the plate that holds the 

boom, so you can have enough angle to make the tension force the ropes, so 
this system function can be applied.
The first step is to place the boom in the ring M6x50mm with nut on each side of 
the screw tightening torque to each side of the boom (Step 1)