24 Bath fitting
WimTec OCEAN B7
EN
OCEAN B7
Assembly
2
5
3
6
1.
Close the main water valve.
2.
Remove the flush-mount protective cover.
3.
Cut off protruding parts from the flush-mount box so it aligns
with the tiles.
4.
Where necessary, seal off space between wall and flush-
mount set with silicone.
5.
Unscrew both mounting clips with a screwdriver until they
align with the tiles.
6.
Feed the connection cable (cable type: 2 x 0.2–0.5 mm
2
) into
the flush-mount casing and connect it to the power supply
(art. no. 117 899 or art. no.
113 792
).
Attention: The power must be switched off, and the pow-
er supply must not be assembled in the flush-mount set
or the protected zone!
ATTENTION!
Perform the following steps
in the order indicated!
!
1
4
