8
9
Basic Controls
Volume Control / Power
Adjusts the volume level and turns on or off the unit.
Mode
Interchanging the operating mode.
Adjust
+, — ENTER — adjusts the sensitivity, DISC or
NOTCH range.
Enter
Used to accept or reject the target in NOTCH mode (it
works with + or -)
Surf Elim
Sets the detector to surface elimination mode.
GND TRAC,GND BAL
Sets ground balance in ALL METAL mode and
pinpointing a target.
Volume Control / Power
Adjusts the volume level and turns on or off the unit.
Basic Operation
Motion and Non-motion Modes
Power On
Turn VOL knob clockwise to turn on the metal detector. The machine runs a self-test
first: All display segments will illuminate and the detector sounds high -medium and
low tones respectively. Then stays in DISC mode after 2~3 seconds.
ALL METAL Mode
A non-motion mode: In this mode, target is detected with the coil motionless over
it, and the detector emits continuous sound (no need to move the coil from side
to side). In ALL METAL Mode, adjust GND BAL controller and then press GND
TRAC several times to eliminate ordinary minerals and ores. The detector sounds a
medium tone to all targets detected.
DISC,NOTCH and AUTO-NOTCH
Modes are motion modes: There are 3 tones to identify different metals in these
modes. Detector can work in auto-ground balance. Sensitivity is adjustable, while
GND BAL is not available in these modes. To reject the trash metal, you may adjust
DISC or NOTCH range. Motion mode means the coil must be in continuous motion,
otherwise target cannot be detected.
Four Operating Modes
Interchangeable among 4 operating modes: DISC, ALL METAL, AUTO-NOTCH,
NOTCH.
Press MODE touch pad to change the operating modes in following order:
DISC→ALL METAL→AUTO-NOTCH→NOTCH→DISC. The operating mode displays
at bottom left corner of the LCD.
DISC mode
Power on the detector, it enters into the default mode DISC automatically. In this
mode, the detector can eliminate unwanted objects from the left of the DIS/NOTCH
range to the right. DISC/NOTCH indicator shows detector’s current discrimination
range, and an object’s probable identification is indicated by the arrows at the
top of the display. SENS shows current sensitivity level. While DEPTH reads out
the estimated target depth. Each time a target is detected, DEPTH indicator will
illuminate. DEPTH indicator shows the relative depth of the target, the larger the
reading is, the farther the target away from the coil.
Adjusting DISC Range
Press ADJ, the display bar of DISC/NOTCH range will blink. Now you can adjust
DISC/NOTCH range. Press“+” to increase the range of discrimination, press “-” to
decrease it.
ALL METAL Mode
Press MODE to enter into ALL METAL mode, the detector now is in non-motion
mode. In this mode, the detector emits only a monotone sound when it finds a target,
and DEPTH indicates relative target signal strength. The stronger the signal is, the
louder the tone is. GND TRAC is used to locate a coin-sized object precisely. To
move the coil above or near the target area, target will be found soon. Please make
sure the detector is well ground balanced before using ALL METAL mode.
(Please refer to Ground Balancing and PINPOINTING in Non-motion
mode.) Target identification is useless in ALL METAL mode. To see target
identification and depth, please change the detector into relative motion mode.
NOTCH Mode
To selectively eliminate one or several metals from the categories, you can use
NOTCH mode. DISC/NOTCH indicator shows current target discrimination range,
