OPERATING INSTRUCTIONS (cont'd)
7
CORD STORAGE
(Models with Heat-HT or Heat & Massage-HM)
1. Before transporting chair, or when heat & massage is
not in use, power cord should be coiled and stored in
the "Hook & Loop" fastener provided as shown, to
prevent tripping on cord, damage to cord, damage to
recliner, etc...
(FIG. 1)
FIG. 1
HEAT & MASSAGE OPTIONS
Control is located on the inside of right arm of chair.
Heating:
Push HEAT button - See indicator light on switch
3 Lights
= High Heat / Bright Light
2 Lights
= Medium Heat / Med Light
1 Lights
= Low Heat / Dim Light
No Light
= HEAT OFF
Allow 5-8 minutes for back and seat to warm to desired TEMP. setting.
Heat will automatically shut off after approximately 60 minutes.
(Timer resets when switch is pressed)
Massage (optional):
Push MASSAGE button
1X
= Lower Back / Low Intensity
2X
= Lower Back / High Intensity
3X
= Upper & Lower Back / Low Intensity
4X
= Upper & Lower Back / High Intensity
5X
= Alternating Upper & Lower Back / High Intensity
6X
= MASSAGE OFF
Massage will automatically shut off after approximately 15 minutes.
(Timer resets when switch is pressed)
• Use a DAMP CLOTH ONLY to clean switch, wiring or power pack (located under seat frame).
• If there is no heat or massage or flashing light on switch - check power cord connections to wall
outlet AND connection of power cord to power pack unit under chair.
• If switch displays a flashing light; Check all accessible wire connectors under chair for possible
loose connections, then contact Winco customer service: 1-800-237-3377.
HEAT
MASSAGE
HEAT ONLY
OR