WINCO / DWL Industries Co.
3
SAFETY INSTRUCTIONS
WARNING
1. Power must be disconnected at the power source prior to
performing any service procedure or repairs.
CAUTION
2. This appliance is hot when in use. Do not let bare skin touch hot
surfaces. Always keep combustible materials such as curtains,
napkins, flammable cleaners, etc., away from the appliance.
x
x
burn hazard.
The unit surfaces and outside covering will be HOT
during and for a short time after use.
uSe caution when touching the unit.
WARNING
CAUTION
HOT
3. Extreme caution is necessary whenever this appliance is used
near children or whenever this appliance is left unattended.
4. Always unplug appliance when not in use, before cleaning,
adjusting, or when general maintenance is performed.
5.
do not
operate this appliance if the cord or plug is damaged or
altered.
do not
operate this appliance if it has been dropped
or damaged. Email returns@winco.com to request support
service for examination, repairs, or electrical and mechanical
adjustments. (See "Warranty" on page 8 for details)
6.
do not
use outdoors. This appliance is not intended for outdoor
use or use in wet or humid locations
7. Plug into properly grounded outlets only. Avoid use of extension
cords.
do not
run power cord under carpeting, runners, or like
items. Keep cord away from foot traffic areas to avoid tripping.
8. Always use this appliance on a non-combustible surface to
reduce the risk of fire.
9.
do not
operate this appliance in areas where flammable liquids
are used or stored.
PREPARATION FOR USE
1. Set unit on a flat and stable non-combustible surface that is near
the power source.
2. Pour 1 to 1.5 inches of water into the unit well pan.
do not
exceed 1.5 inches.
do not
operate without water in the well pan
.
Use of the unit without water will cause metal fatigue and
excess wear on metal components, resulting in rendering the
unit non-operable.
Use care when handling hot water and steam.
3. If the unit fails to work properly during initial use, please notify
customer service at: returns@wincous.com
OPERATION
1. Plug cord into properly grounded outlet with the correct voltage
and power requirement. Electrical shock may occur if appliance is
not grounded properly.
2. Preheat the water in the well pan. Faster preheat can be
achieved by covering the water well pan with an empty full size
food pan or a full size food pan cover.
unit
pre-heating time in minutes
hot water
cold (tap) water
FW-S500
12
20
FW-S600
10
15
Set the heat control to the maximum heat setting for the
following specified times:
3. Place stainless steel or high heat poly pans (inset pans) into the
unit well pan. If using the appliance as a warmer (FW-S500
or FW-S600), the contents placed in the food pans should be
previously cooked as the purpose of the warmer is to hold
contents at the proper desired temperature.
If the appliance is being used as a cooker (FW-S600 only), frozen
foods such as soups, chili or vegetables can be brought to safe
serving temperature (min 140°F) in less than 40 minutes, using
the maximum heat setting.
Place frozen foods into the recommended inset pan(s) and
follow the preparation instructions that accompany the frozen
food product.
4. Never place foods directly into the well pan.
The well pan is
for water only. Foods must always be placed into the inset pans.
5. Inset pans must be covered to maintain temperatures while food
is not being served.
6. For the function of hot food holding, set the heat control to the
desired setting.
Monitor temperature regularly to ensure food safety.
7. During normal operation for food warming and holding,
periodically check the water level. Add hot water when
necessary and stir food occasionally.
Total Restaurant Supply - https://totalsupply1.com - Toll Free 1-800-944-9304 - Local 507-288-9454
2940 Hwy 14 W, Rochester, MN 55901
