background image

2

INTRODUCTION

Congratulations on the purchase of your KATTEX machine. Please take the time to carefully read through 

this manual to ensure the machine is operated and maintained properly, to ensure the best possible 

performance from this product for many years.

WINCO will not accept liability if:

• The instructions in this manual have not been followed correctly.
• Non-authorized personnel have tampered with the machine.
• Non-original spare parts are used.
• The machine has not been handled and cleaned correctly.
• There is any use damage to the unit.

SAFETY

WARNING:  IMPROPER INSTALLATION, 

ADJUSTMENT, ALTERATION, SERVICE OR 

MAINTENANCE CAN CAUSE PROPERTY DAMAGE, 

INJURY, OR DEATH. READ THE INSTALLATION, 

OPERATION, AND MAINTENANCE INSTRUCTIONS 

THOROUGHLY BEFORE INSTALLING OR 

SERVICING THIS EQUIPMENT.

CAUTION: THESE MODELS ARE DESIGNED, 

BUILT, AND SOLD FOR COMMERCIAL USE ONLY. 

IF THESE MODELS ARE POSITIONED SO THE 

GENERAL PUBLIC CAN USE THE EQUIPMENT, 

MAKE SURE THAT CAUTION SIGNS, WARNINGS, 

AND OPERATING INSTRUCTIONS ARE CLEARLY 

POSTED NEAR EACH UNIT SO THAT ANYONE 

USING THE EQUIPMENT WILL USE IT CORRECTLY 

AND NOT INJURE THEMSELVES OR HARM THE 

EQUIPMENT.

WARNING:  A FACTORY AUTHORIZED SERVICE 

PROVIDER SHOULD HANDLE ALL MAINTENANCE 

AND REPAIR. BEFORE DOING ANY MAINTENANCE  

OR REPAIR, FOLLOW SERVICE SET UP 

ARRANGEMENT.

AVERTISSEMENT: TOUTE INSTALLATION, 

RÉGLAGE, MODIFICATION, RÉPARATION OU 

ENTRETIEN INCORRECT PEUT OCCASIONNER 

DES DOMMAGES MATÉRIELS, DES BLESSURES 

GRAVES OU LA MORT. LIRE LES INTRUCTIONS 

D'INSTALLATION, D'UTILISATION ET D'ENTRETIEN 

ATTENTIVEMENT AVANT D'INSTALLER OU DE 

RÉPARER CET APPAREIL.

ATTENTION: CES MODÈLES SONT CONÇUS, 

FABRIQUÉS, ET VENDUS POUR UN USAGE 

COMMERCIAL SEULEMENT. SI CES MODÈLES 

SONT PLACÉS POUR QUE LE GRAND PUBLIC 

PUISSE LES UTILISER, ASSUREZ-VOUS QUE LES 

CONSIGNES D’ATTENTION, D'AVERTISSEMENT, 

ET LES INSTRUCTIONS D'UTILISATION SOIENT 

CLAIREMENT AFFICHÉES PRÈS DE CHAQUE UNITÉ 

DE SORTE QUE N'IMPORTE QUEL UTILISATEUR DE 

L'APPAREIL L'EMPLOIE CORRECTEMENT ET NE SE 

BLESSE PAS OU N'ENDOMMAGE PAS L'APPAREIL.

AVERTISSEMENT: UN TECHNICIEN AUTORISÉ PAR 

L'USINE DEVRA EFFECTUER TOUT L'ENTRETIEN 

ET LES RÉPARATIONS. AVANT DE FAIRE TOUT 

ENTRETIEN OU RÉPARATION, VEUILLEZ 

CONTACTER WINCO.

WARNING: THE BLADES ARE 

VERY SHARP

PLEASE USE CAUTION WHEN HANDLING AND 

OPERATING THE MACHINE AND KEEP HANDS 

AWAY FROM ALL CUTTING EDGES.

AVERTISSEMENT: TRÈS COUPANTES 

TRÈS 

COUPANTES

. VEUILLEZ FAIRE PREUVE DE 

PRUDENCE LORSQUE VOUS MANIPULEZ ET 

UTILISEZ LA MACHINE ET GARDEZ LES MAINS 

ÉLOIGNÉES DE TOUS LES BORDS DE COUPE.

Summary of Contents for KATTEX TLC-1









Reviews: