17
Getting Started
This chapter tells you how to set up the system.
Setting Up the System
The following is a summary of the steps in setting up the
system for use.
CAUTION: Make sure that power to the system and
each of the devices to be connected is switched OFF
before plugging in the connectors.
1.
Make any required external connections such as the
keyboard, and mouse.
2.
Plug the appropriate end of the power cord into the power
connector of the system. Then plug the other end of the power
cord to an electrical outlet.
3.
Press the power switch of the system to turn on the system’s
power.
4.
If necessary, run the BIOS SETUP program to configure the
system (see Chapter 3).
5.
Install the software drivers if necessary.
Summary of Contents for WTP-8865 series
