40
When enabled, the video is off in suspend mode. The default setting
is
Yes
.
Suspend Type
The default setting for the Suspend Type field is
Stop Grant
.
Modem Use IRQ
This field sets the IRQ used by the Modem. By default, the setting is
3
.
Suspend Mode
When enabled, and after the set time of system inactivity, all
devices except the CPU will be shut off. By default, the setting is
Disabled
.
HDD Power Down
When enabled, and after the set time of system inactivity, the hard
disk drive will be powered down while all other devices remain
active
.
Soft-Off by PWR-BTTN
This field defines the power-off mode when using an ATX power
supply. The
Instant Off
mode allows powering off immediately upon
pressing the power button. In the
Delay 4 Sec
mode, the system
powers off when the power button is pressed for more than four
seconds or enters the suspend mode when pressed for less than 4
seconds.
Summary of Contents for WTP-8865 series
