JavaPOS Demo Application: Getting Started
BEETLE /moPOS "Getting Started"
35
In case the user presses the “Disconnect”- Button, tablet A will lose its connection to the POS
Device HUB and all devices will lose their connection. On tablet A the message box
will be shown. Additionally, the shown connection state at the tablet A on the upper right
corner will change to state “not connected”.
On tablet B, however, then the successful connection will be shown by a message box and
the connection-state on the upper right corner. The re-activation of the devices from tablet
B happens automatically, once you are connected to the POS Device HUB.
5.6.6
Reconnecting to the POS Device HUB
You can reconnect to any POS Device HUB, by proceeding like previously described in
“Configuring POS Device HUB” or in “Installation and configuring the tablet”.
The re-activation of the devices happens automatically, once you are connected on the POS
Device HUB.
5.6.7
Disconnection detection
If you are currently connected to the POS Device HUB and problems on the wireless network
are detected, or if you are out of range of the Wireless Router, this will disconnect the appli-
cation from the POS Device HUB, and you will then see the following message box:
Click on the OK button to make the message box disappear and you can then try again man-
ually to reconnect to the desired POS Device HUB.
