READING THE KINETIC WAVE DISPLAY
The kinetic wave display shows the main unit (receiver) signal
reception strength. The wave icon is located above the remote
channel number and indicates the reception status from the
remote sensor. Three types of reception status may be displayed:
NOTE: If the indoor or remote temperature and/or humidity goes
above or below operating range stated in specifi cations, the main
unit’s display will show dashes “- - -”
TEMPERATURE AND HUMIDITY TRENDS
The temperature and humidity trend indicators are located next
to the temperature and humidity display lines. They show the
trend of temperature and humidity readings collected indoors
and at a particular remote site. There are three trends that can be
displayed: Rising, Steady, and Falling.
COMFORT LEVEL INDICATORS
The Easy-Read Thermometer/Hygrometer is capable of detect-
ing and displaying the present comfort levels for the surround-
ing environment. The environmental comfort level is detected,
interpreted, and displayed on the main unit’s display based on
the combination of the current indoor and remote temperature
and humidity readings. There are several comfort levels that may
be shown: COM (comfortable); WET (wet); DRY (dry) and No
Indicator.
Searching for Signal
Readings are
Securely Registered
No Signal Detected
Temperature/
Humidity Trend
Rising Steady Falling
Arrow
indicator
Indicator
Displayed
Temperature
Range
Humidity
Range
Shows Current
Condition
COM
68° to 77°F
40 to 70% RH
Ideal for both
relative humidity
and temperature
WET
23° to 122°F
Over 70% RH
Contains excess
moisture
DRY
23° to 122°F
Below 40% RH
Contains inad-
equate moisture
No Indicator
Less than 68° or
more than 77°F
40 to 70% RH
No Comment
MAXIMUM AND MINIMUM MEMORY
The maximum and minimum record of the indoor and remote
temperature and humidity will be automatically stored in the
memory of the main unit (receiver).
1. To display the minimum, maximum, or the current reading,
press
MEMORY
button after desired mode (indoor or remote)
is selected.
2. If no button is pressed for the next 15 seconds, the unit will
return to the current temperature and humidity display for
applicable mode.
3. To clear the memory, press and hold
MEMORY
button for two
seconds and all previously stored readings will be erased.
10
11
