*Dimension does not include 3/8” wide flange around liner.
**The inside depth shown in the table above assumes a minimum cabinet backboard thickness of 3/8”.
20
1/2
” - 23
1/2
” 20
1/8
” - 23
1/8
”
20
1/2
” - 23
1/2
” 20
1/8
” - 23
1/8
”
Without Backboard
**With Backboard
*Inside Depth (
B
)
*Inside
Width (
A
)
Liner
Model
Custom Hood
Exterior Width
Insert
Model
UL2936S
UL2942S
UL3848S
UL3860S
36 inches
42 inches
48 inches
60 inches
UIX2916S
UIX3816S
34
1/2
”
40
1/2
”
46
1/2
”
58
1/2
”
2
1/16'
'
A
B
3/4''
Plywood base thickness: 3/4”
thickness:
FIG 1
Installation - Stainless Steel Liner
Recommended
WARNING:
When building a custom hood for a liner, always follow all applicable construction codes and standards.
See the illustrations and table below to locate your liner choice and use corresponding custom hood
base dimensions. For the liner installation, only the bottom of the custom hood is needed. Do not
finalize the entire custom hood yet, because an opening is needed for the insert.
FIG 1:
Consider the shape and size of the insert to determine the configuration of the custom hood. For
more details, refer to the installation manual for the UIX2916S and UIX3816S inserts.
SEP12.0201
UL29xxS and UL38xxS Liners
www.windcrestcnp.com
1
Wind Crest™ by CNP Industries, Inc.
351 Thor Place
Brea, CA 92821
877-387-6721 (toll free)
714-482-2320
We recommend the base of the custom hood to be 3/4” thick plywood. The sides, front
and backboard (if included) of the custom hood to be 3/4” thick, assuming standard
cabinet widths.
UL3854S
54 inches
52
1/2
”
