Wind WD25TC-IN, Operation Manual

Operation

BLANK

1.After unit starts, select your desired operation mode.

2.Press TIMER button to change TIMER mode. Every

time the button is pressed, display changes as follows:

Remote controller:

TIMER ON TIMER OFF

TIMER ON-OFF

Then select your desired TIMER mode (TIMER ON or

TIMER OFF or TIMER ON-OFF). "        "or "       "will flash.
3.Press        /

button to set time.

Press the button for each time, setting time in the first 

12 hours increased by 0.5 hour every time, after 12 

hours,increased by 1 hour every time.

Press the button for each time, settiing time in the first 

12 hours decreased by 0.5 hour every time, after 12 

hours,decreased by 1 hour every time.

It can be adjusted within 24 hours.

0.5h

0.5h

0.5h

0.5h

time ON or OFF button will not flash any more.

5.Cancel timer setting

Press the timer button by times until the  time display

eliminated.

Hints:

After replacing batteries or a power failure happens, time

setting should be reset.

According to the Time setting sequence of TIMER ON or

TIMER OFF, either Start-Stop or Stop-Start can be achieved. 

button and confirm the

4.Confirm timer setting

After adjust the time,press

Press               button to enter additional options,Press this 

button continuously, the louvers location will cycle between 

in the following three locations, to choose the swing location 

what you needed,and then press                 button to confirm.

 Timer On/Off  On-Off Operation 

Climate:T1

Voltage:230V

CE

All the products are in conformity with the following 

European provision:

RoHS

Your air conditioning product is marked with this

symbol.This means that electrical and electronic

products shall not be mixed with unsorted 

household waste. Do not try to dismantle the 

system yourself : the dismantling of the air

The products are fulfilled with the requirements in the 

directive

2011/65/EU

 of the European p arliament and of

council on the Restriction of the use of Certain Hazardous

Substances in Electrical and Electronic Equipment (EU 

RoHS Directive)

WEEE

In accordance with the directive 

2012/19/EU

of the European

parliament, herewith we inform the consumer about the dis-

posal requirements of the electrical and electronic products.

DISPOSAL REQUIREMENTS:

EUROPEAN REGULATIONS

CONFORMITY FOR THE MODELS

1

1+2=

kg

R32

2

kg

2=

1=

B

C

D

F

E

kg

A

IMPORTANT INFORMATION REGA-

RDING THE REFRIGERANT USED

This product contains fluorinated greenhouse gases covered by 

the Kyoto Protocol. Do not vent into the atmosphere.

Refrigerant type:R32

GWP* value:675

GWP=global warming potential

Please fill in with indelible ink,

 and

on the refrigerant charge label supplied with the product.

The filled out label must be adhered in the proximity of the product

charging port (e.g. onto the inside of the stop value cover).

A  contains fluorinated greenhouse gases covered by the Kyoto 

Protocol

B  factory refrigerant charge of the product: see unit name plate

C   additional refrigerant amount charged in the field

D   total refrigerant charge

E   outdoor unit

F   refrigerant cylinder and manifold for charging 

Contains fluorinated greenhouse gases

covered by the Kyoto Protocol

 Healthy airflow Operation

conditioning system,treatment of the refrigerant, of oil and of

other part must be done by a qualified installer in 

accordance

with relevant local and national legislation. Air conditioners 

must be treated at a specialized treatment facility for reuse, 

recycling and recovery. By ensuring this product is disposed 

of correctly, you will help to prevent potential negative cons-

equences for the environment and humen health. Please 

contact the installer or local authority for more information. 

Battery must be removed from the remote controller and dis-

posed of separately in accordance with relevant local and 

nationl legislation.

1.Press          to starting

Setting the comfort work conditions.

2.The setting of healthy airflow function

4.In cooling and dry, using the air conditioner for a long

time under the high air humidity, condensate water may

occur at the grille .

3.The cancel of the healthy airflow function

Press               button to enter additional options,Press this

button continuously, the louvers location will cycle between

in the following three locations again,and then press

button to cancel.

Notice: Do not direct the flap by hand. Otherwise, the

grille will run incorrectly. If the grille is not run correctly, stop

for a minute and then start, adjusting by remote

controller.

Note:

1.After setting the healthy airflow function, the position

grill is fixed.

mode.

mode.

2.In heating, it is better to select the

3.In cooling, it is better to select the

TIMER OFF-ON

Healthy

airflow

upwarder

Healthy

airflow

downwarder

Present

position

4

2014/53/EU(RED) 2014/517/EU(F-GAS)

2009/125/EC(ENERGY)

2010/30/EU(ENERGY)

2006/1907/EC(REACH)

CONFIRM

CANCEL

EXTRA

FUNCTION

EXTRA

FUNCTION

CONFIRM

CANCEL

CONFIRM

CANCEL