41
Maintenance
Replacing or Installing Scrub Brushes -
Cylindrical
1.
Turn machine function dial to transport mode,
allowing deck to return to “up” position. Turn the
machine power off.
FOR SAFETY: Before leaving or servicing the
machine; stop on level surface, turn OFF machine
and remove key.
2.
On right and left sides of deck, turn both brush and
skirt releases 1/4 turn counter-clockwise.
3.
Swing deck skirts out. Remove brush end caps.
Slide brushes out the sides of deck.
4.
To reinstall, slide brushes into deck. Replace
brush end caps. Lift end cap up and turn brush
release 1/4 turn clockwise, locking brush in place.
Swing deck skirt back to deck. Turn skirt release
1/4 turn clockwise, locking skirt into place.
NOTE: Check that brush end cap is properly secured
into deck housing. Check that brush is suspended off
ground while deck is in “up” position.
86367610 Chariot CS26
