50
Maintenance
Transporting
Pushing Machine
The machine may be pushed for short distances at
speeds not to exceed 5 mph. Be careful to avoid
damaging machine. The machine may be pushed by
hand from the rear.
NOTE: To avoid damage caused by regenerative
voltage, disconnect traction motor before towing or
pushing machine.
Machine Tie-Downs
There are four tie down points, two on the front wheel
guards, and two on the rear axle located on either side
of the foot box.
Preparation for Loading/Unloading Trailer
Before loading or unloading machine from trailer,
remove squeegee, scrub deck, side skirts or side
squeegees, Aqua-Mizers and scrub brushes (pads) to
eliminate interference with tie-downs.
Scrub head must be in the up position before loading.
When transporting the machine on a trailer or in a truck,
in addition to using tie-downs, be sure to set the parking
brake, and block the tires to prevent the machine from
rolling
86367610 Chariot CS26
Tie down point
Tie down point
Wheel Guards
Rear Axle
(Both sides)
(Both sides)
