drill them
side cutters
cross screwdriver
electrical components
Wall
4
5.1.2. mounting location
The following tools are for installing and wiring the Windsy Wallbox 11 kW
multimeter
fire hazard,
explosion,
strip the cable
number tool
with ÿ 5mm
crimping tool
1. The EV charging station
must only be installed
on non-combustible
material such as a
concrete base.
Check the electrical
connection and measure the
voltage
6
3
3. Visual inspection of all
cut cable
mounting holes in the
tighten the screws
before initial start-up
5.1.1. tools
The Windsy Wallbox 11 kW can be installed both indoors and
outdoors. The charging station should be installed protected from
wind and direct rain. It is recommended to mount the charging station
in a place with non-combustible materials, good ventilation and away
from direct sunlight to avoid possible overheating. It should also be
mounted in a location free from vibration and shock, and above
ground level and drainage to prevent water damage. In order to
ensure good ventilation, the charging station should be mounted
vertically with a clearance of at least 30 cm on all sides.
1
wire stripper
impact drill
necessary and should be available.
5
death or serious
injury. Serious
damage to property and loss of
property.
pressing ferrules
2
Scheme drawing application
2. The EV charging station
must be protected from
direct rain.
4. The EV charging station
should not be installed in
areas that
Valid from:
03-28.03.2022
EV-I-1000025-01
Page 16 of 31
Windsy Wallbox Home 11 kW
operation manual
Machine Translated by Google
