There are two common ways to end the charging process in Plug & Charge mode and to pull the plug out of the vehicle:
A visual inspection for damage should always be carried out before charging. In particular, the contact
area of the charging plug should be checked for dirt and moisture, the charging cable for cuts or
abrasions on the insulation, and the cable outlet of the charger for secure seating. Operation with
damage is strictly prohibited.
2. The charging process can be manually interrupted for a partial charge by unlocking the vehicle. This stops the
charging process from the vehicle
Risk of electric shock. personal injury. property damage.
Corresponding instructions for unlocking or stopping the charging process from the vehicle side can be
found in the relevant vehicle manufacturer's manual.
charging socket of your vehicle. The "Connect" LED of the charging station lights up
and indicates that the connection to the vehicle is established.
In the RFID mode, the charging process can also be ended by holding your RFID card up to the reader.
It is strictly forbidden for minors or unauthorized persons to approach the charging station to avoid
injury.
1. Take the charging plug out of the holder and plug it into the
2. In the case of the Plug & Charge setting, the charging station starts charging directly. In the RFID
mode, the associated card must first be swiped over the RFID reader before the loading process
starts.
(requires vehicle support). The "Charging" LED display goes out and the charging process is ended. The
charging plug can now be removed.
It is not recommended to charge during bad weather and thunderstorms.
6.3.2. stop loading
Risk of electric shock. Serious injury, property damage.
Pulling on the cable can loosen and damage the contact in the plug.
Charging is strictly prohibited if the electric vehicle or charging station fails.
3. As soon as the "Charging" LED starts flashing, the charging process has started. Information related to
the charging process is shown on the display.
Only pull the charging label out of the connection by the plug and not by the cable.
6.3.1. Start charging
1. When fully charged, charging will stop automatically and the charging plug can be pulled out of the vehicle. If the
adapter cannot be removed, the vehicle is usually locked and must first be unlocked.
In the event of an emergency (e.g. fire, smoke, unusual noise, etc.), press the charging
station's red "Emergency Stop" button and stay away from the charging station. Emergency number
112 (fire brigade) in Germany in the event of a fire or fire.
Page 26 of 31
Valid from: 03-28.03.2022
EV-I-1000025-01
operation manual
6.3. loading process
Windsy Wallbox Home 11 kW
Machine Translated by Google
